LG SH3K - Page 2

Front Panel
Rear Panel
··································Standby /On
·······························Selects Function
··························Adjusts Volume
PORT. IN ············· Connect to a Portable device
OPTICAL IN ···········Connect to an Optical device
Subwoofer Connection1
Place the wireless subwoofer near the sound bar and
follow steps below.
a Connect the power cord of wireless
subwoofer to the outlet.
b Turn on the sound bar :
The sound bar and wireless subwoofer will
be automatically connected. The subwoofer's
yellow - green LED turns on.
Subwoofer Connection Manually
a Reset the Subwoofer
If the yellow - green LED on the subwoofer
blinks rapidly, skip this step and go to
b
y
Press and hold PAIRING button for 5 seconds.
y
The LED lights up alternately in red and
yellow - green.
y
Unplug the power cord. After the LED turns off
completely, plug in the power cord again.
When the reset is completed, the subwoofer's
yellow - green LED blinks rapidly.
b Reset the sound bar
y
Adjust volume to minimum until the red LED on
the sound bar lights up for a while.
y
Press and hold
(Mute) button on the remote
control for 3 seconds.
y
The red LED on the sound bar blinks rapidly.
y
Turn the sound bar’s power off and on while the
subwoofer’s yellow - green LED blinks.
When the connection is completed, you can see the
yellow - green LED on the subwoofer.
Keep the sound bar and the subwoofer
away from the following (ex. wireless router,
microwave oven, etc.) over 1m (3.3 ft) to
prevent wireless interference.
!P
a Connect the the sound bar to the TV using
Optical cable.
b Set up [External Speaker (Optical)] on your TV
setting menu.
TV
TV Connection 2 Remote control
Additional Device Connection
a Connect to the external device as follows.
TV
(Set-top
Box, Player
etc.)
b Set the input source by pressing F on the
remote control or unit repeatedly.
Additional Information
ASC/BASS BLAST/CINEMA: Selects sound effect.
NIGHT ON/OFF: Turns down the volume at night.
WOOFER LEVEL +/-: Adjusts the volume level of subwoofer.
AUTO POWER ON/OFF: Automatically turns on by an input
source.
Replacement of battery
Specication
Power
requirements
Refer to the main label.
Power
consumption
Refer to the main label.
Dimensions
(W x H x D)
Approx.
950 mm x 71 mm x 47 mm
(37.4 inch x 2.8 inch x 1.9 inch)
Amplier
(Total RMS
Output power)
300 W RMS
Design and specications are subject to change
without notice.