49TROUBLESHOOTING
ENGLISH
Error Codes
Problem Possible Cause Solutions
Washer fills with
water slowly or not at
all, or
Water supply faucets are not fully
open.
• Make sure that the water faucets are fully open.
Water line hoses are kinked,
pinched, or crushed.
• Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
Water inlet filters are clogged.
• Clean the inlet filters. See Maintenance in the
Care and Cleaning section.
Water supply pressure to faucet or
house is too low.
• Check another faucet in the house to make sure
that household water pressure is adequate and
flow is not restricted. Disconnect the inlet hose
from the washer and run a few gallons of water
through the hose to flush the water supply lines.
If flow is too low, contact a plumber to have the
water lines repaired.
Water supply connected with
leaklimiting hoses.
• Hoses designed to limit leaks can trip falsely and
prevent the washer from filling. The use of leak
limiting hoses is not recommended.
If the balance is not successful,
this error will be displayed.
• The automatic attempt to rebalance the load was
not successful. The cycle has been paused to
allow the load to be manually adjusted.
The load is too small.
• Small loads may need additional items to be
added to allow the washer to balance the loads.
Heavy articles are mixed with
lighter items.
• The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
The load is out of balance.
• Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
To Next Page
Loading...
