7
SAFETY INSTRUCTIONS
CAUTION
y
Make sure the product ventilation hole is not blocked. Install the product in
a suitably wide place (more than 10cm from the wall)
-
- If you install the product too close to the wall, it may be deformed or fire
can break out due to internal heat.
y
Do not block any of the ventilation openings. Install in accordance with the
manufacturer’s instructions.
-
- The product can be deformed or fire can break out due to overheating
inside the product.
y
Install the product on a flat and stable place that has no risk of dropping
the product.
-
- If the product is dropped, you may be injured or the product may be
broken.
y
When installing the product on a table, be careful not to place it near the
edge.
-
- This may cause the product to fall causing serious injury to a child or
adult and serious damage to the product. Only use a suitable stand.
y
Do not place the product close to source of steam or oil such as a
humidifier.
-
- This may create a fire hazard or an electric shock hazard.
y
Keep the product away from direct sunlight.
-
- The product can be damaged.
y
Do not place the product in a built-in installation such as bookcase or rack.
-
- Ventilation required.
y
Do not unplug the power cord while the product is in use.
-
- Electrical shock can damage the product.
y
Ensure the power cord does not come into contact with hot objects such as
a heater.
-
- This may cause a fire or an electric shock hazard.
y
Most appliances recommend they be placed upon a dedicated circuit;
that is, a single outlet circuit which powers only that appliance and has no
additional outlets or branch circuits.
y
Do not overload wall outlets. Overloaded wall outlets, loose or damaged
wall outlets, extension cords, frayed power cords, or damaged or cracked
wire insulation are dangerous. Any of these conditions could result in
electric shock or fire.
To Next Page
Loading...
Need help?
General
