18
EN
CAUTION
• Adjust the band clamps to prevent the hoses
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain
connector helps avoid siphoning, odors, or
improper draining.
• Make sure the drain hose is not kinked or
pinched. This is a potential cause of drainage
problems or noise.
NOTE
• Depending on the installation environment,
you may have to purchase a separate drain
hose connector.
Leveling the Appliance
If the floor is uneven, turn the adjustable feet as
required (Do not insert pieces of wood etc.
under the feet). Make sure that all four feet are
stable and resting on the floor and then check
that the appliance is perfectly level (Use a spirit
level).
• Once the appliance is level, tighten the lock
nuts up towards the base of the appliance. All
lock nuts must be tightened.
Raise Lower
Lock nut
Tighten all 4
lock nuts securely
Diagonal Check
• When pushing down the edges of the top
plate diagonally, the appliance should not
move up and down at all (check both
directions). If the appliance rocks when
pushing the machine top plate diagonally,
adjust the feet again.
WARNING
• When stacking Main Washer on Mini Washer,
use the leveling feet on Mini Washer to level
both. Main Washer´s leveling feet should be
minimized and the locknuts turned counter-
clockwise to secure them.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and
unbalance.
• If Mini Washer is installed on a raised
platform, it must be securely fastened in order
to eliminate the risk of falling off.
To Next Page
Loading...
