16
ENGLISH
USING THE REMOTE CONTROL
Replacing the Remote Control Battery
1 To separate the battery tray on the back of the remote control, push the hook
to the side and then pull it.
2 Align the side of the replacement battery to the battery tray label and
insert them correctly.
3 Push the battery tray in until it clicks.
The illustrations may differ from the actual accessories.
(Power) Turns the monitor on or off.
(Input) Selects the input mode.
(Volume) Adjusts the volume.
(Mute) Mute all sounds.
(Brightness) Adjusts the brightness level.
(Previous) Go to the previous step.
Makes the main menu screen appear or
disappear.
(Reader mode) Changes to Reader mode.
(Direction and OK buttons)
You can move, select, and adjust the menu.
* (Down): Enters the [Accessibility] menu if no other OSD (On
Screen Display) is displayed.
(User-defined Key) Enters the menu user specified.
(OLED Care) Enters the [OLED Care] menu.
([DTS Headphone:X]) Selects the desired sound setting.
(Sound Out) Changes the audio output method.
CAUTION
• Do not mix old and new batteries, as this may damage the remote control.
• Be sure to point the remote control toward the remote control sensor on the monitor.
• The product’s internal and external batteries should not be exposed to excessive heat such as direct sunlight,
fire, or the like.
• Risk of fire or explosion if the battery is replaced by an incorrect type.
• Do not ingest battery. Chemical burn hazard.
To Next Page
Loading...
