2-34
X501
< MAIN board top view >
ONE POINT REPAIR GUIDE
When you turn on your set, it will display “WELCOME” on front panel, and it will not boot-up normally.
2-6. X501
2-6-1. Solution
Replace X501 on MAIN board.
2-6-2. How to troubleshoot (Countermeasure)
1) Please check the soldering status of 27 MHz crystal (X501).
2) Please check the frequency of 27 MHz crystal (X501).
3) If the crystal doesn’t oscillate, replace X501.
4) After changing it, if the set is still not booting:
- Check eMMC flash IC (IC506) refer to item 2-7.
- Check DDR IC (IC503, IC504, IC505) refer to item 2-8.
- Check MT8580 IC (IC501) refer to item 2-9.
2-6-3. Service hint (Any picture / Remark)
To Next Page
