§
How to disassemble the transit bolts.
ƒUTo protect the washer during transportation, the special
4 bolts are locked. Before operating the washer, remove
the bolts.
( If they are not removed, it may cause heavy vibration, noise and
malfunction)
1. Locate the 4 bolts that secure the washer.
2. Unscrew the 4 bolts with a spanner provided.
3. Take out the 4 bolts.
§
Level adjustment
1. Select a place for installation
ƒUPlace it on a firm and even floor
ƒUPlace it more than 2cm away from the wall or other
furniture
2.Check the gap
ƒUEnsure all feet are firmly on the floor.
3.Level adjustment
ƒUAfter adjusting the level, check it by shaking the washer.
Readjust the level if necessary.
ƒULevelling should be done within 1.5 degree angle.
ƒUKeep the transit bolts and spanner
for future use
in case the machine is to be
transported again.
ƒUIf the washer is not levelled, it may cause
noise or vibration.
§
Electrical connection
ƒUDo not use an extension cord or double adapter.
ƒUIf the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly
qualified person in order to avoid a hazard.
ƒUAlways unplug the machine and turn off the water supply after use.
ƒUConnect the machine to an earthed socket in accordance with current wiring regulations.
ƒUIf the appliance is supplied from a cord extension set or electrical portable outlet device, the
cord extension set or electrical portable outlet device should be positioned so it is not subject
to splashing or ingress of moisture.
ƒUIf a stationary appliance is provided with a supply cord and a plug, the instructions shall state
that the appliance must be positioned so that the plug is accessible.
Caution