6
§
Water drain
ƒUHook over the edge of a sink using the plastic hose hanger supplied with the machine.
ƒUMake sure there are no kinks in the hose and that it is not crushed.
Secure the hose so that it can not be dislodged while the appliance is running.
ƒUThe drain hose should not be placed higher than 85cm above the floor.
§§
ö
Connecting the inlet hose
1.
Unscrew the fixing screw to
attach the faucet.
2.
Push the connector up till the
rubber packing is in tight contact
with the faucet. Then tighten the 4
screws.
3
Push the water supply hose
vertically upwards so that the
rubber packing within in the hose
can adhere completely to the
faucet and then tighten it by
screwing it to the right.
¥ Make sure that the rubber seal is
inside the hose connector.
¥ Your machine comes with only
cold water connection.
¥ Make sure that there are no kinks
in the hose and that it is not
crushed.
¥ Two rings are supplied with the water inlet hose in the valve
connector in order to prevent water leaks.
¥ Your machine comes with only cold water connection.
Connect to cold water using the inlet valve.
¥ Check water tightness of washing machine connections by
turning the tap completely on.
¥ Periodically check the condition of the hose and replace the
hose if necessary.
¥ Make sure that there are no kinks in the hose and that it is not
crushed.
§§
ö
Connecting the inlet hose (How to connect the hose of screw type.)
To Next Page
Loading...
Need help?
General
