SPIN TROUBLE
Check the sensor
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose, replace
the sensor or the hose.
Normal
Reconnect or repair it.
Replace the motor assy.
(4681FR1194A)
Check the frequency of the
water level 48 or more. The frequency can be
checked by pressing the £ Wash£and £ Rinse£
buttons at the same time.
Press £ Power£button with both £ Rinse£and £ Spin£
buttons pressed after power off. Press £ Start/Pause£
button 2 times. Does the drum rotate at low spin
speed?
Is it disconnected or badly contacted?
¡aNatural:3pin(¤ ),Red:4pin(¤Ł),Blue:2pin(¤Ø),
Yellow:2pin(¤Œ)¡b
Check the motor connector, is the resistance between
the terminal in figure the same as below?
Resistance between terminals
¤ ~¤º:0.5~1.0§
¤º~¤ :1.5~2.5§
Be sure to unplug the machine before measuring.
MOTOR TERMINAL
Replace the PWB assy (Main)
To Next Page
Loading...