28
INSTALLATION
2
Remove the guide plate
e
if the tap is too large
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
f
down, push
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Connecting the Hose to the
Appliance
1
Connect the 2 blue hoses
b
to the Y connector
a
.
2
Attach the inlet hoses to the back of the
appliance and secure the cold water inlet hoses
with tie straps
e
.
For the Washer
• Attach the hot water inlet hose
c
to the hot
water inlet on the back of the washer. Attach
the cold water inlet hose
d
to the cold water
inlet on the back of the washer.
For the Dryer
• Attach the cold water inlet hose
d
to the
cold water inlet on the back of the dryer.
• Tighten the fittings securely. Turn on both
faucets all the way and check for leaks at
both ends of the hoses.
To Next Page
Loading...
