77
TROUBLESHOOTING
ENGLISH
Steam Function
Clothes have damp
spots after a dry cycle.
Very large load or very small load. Single large item such as a blanket or
comforter.
• If items are too tightly packed or too sparse the sensor may have trouble
reading the dryness level of the load. Use a
Tiempo de Secado (Time Dry)
cycle for very small loads.
• Large, bulky items such as blankets or comforters can sometimes wrap
themselves into a tight ball of fabric. The outside layers will dry and
register on the sensors, while the inner core remains damp. When drying
a single bulky item, it may help to pause the cycle once or twice and
rearrange the item to unwrap and expose any damp areas.
• To dry a few remaining damp items from a very large load or a few damp
spots on a large item after a sensor cycle has completed, empty the lint
trap, and then set a
Tiempo de Secado (Time Dry)
cycle to finish drying
the item(s).
Symptoms Possible Cause & Solution
Water drips from
nozzle when Steam
cycle starts.
This is normal.
• This is steam condensation when Steam cycle starts. The dripping water
will stop after a short time.
Steam does not
generate, but no error
code is shown.
Water level error.
• Unplug dryer and call for service.
Water drips from door
during Steam cycle.
This is normal.
• Condensation will normally form on the inside of the dryer door during
steam operation. Some condensation may drip out the bottom of the door.
Steam is not visible
during Steam cycle.
This is normal.
• Steam vapor is difficult to see when the door is closed. However,
condensation will normally form on the inside of the dryer door if the
steam system is operating normally.
Drum does not turn
during Steam cycle.
This is normal.
• The drum is turned off so that the steam vapor remains in the drum. The
drum will normally turn for about 2 seconds once a minute.
Cannot see steam
vapor at the beginning
of cycle.
This is normal.
• Steam is released at different stages of the cycle for each option.
Symptoms Possible Cause & Solution
To Next Page
Loading...
