LG WM2277H Series - Maintenance; Cleaning the Water Inlet Filter; Cleaning the Drain Pump Filter

MAINTENANCE
Before cleaning the washer interior, unplug the electrical power cord to as oid electrical shock hazards.
When disposing of the appliance, cut ofT the power cable, destroy the plug, and disable the dtair luck to prevent
young children from being trapped inside.
■ The water inlet filter
•" IE " error message will blink on the control panel when water does not enter the dispenser
• if your water is very hard or contains traces of time deposit, the water inlet filter may become clogged.
We recommend cleaning it every few months.
1. Turn off the
water tap.
2. Unscrew
the water
inlet hose
3. Clean the
filter using
a hard
bristle
brush.
4. Tighten
the inlet
hose.
■ The drain pump filter
■ The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
A CAUTION
Drain, using the drain hose, before opening the pump filter to remove objects.
Be careful when draining if the water is hot.
■ Allow the water to cool down before cleaning the drain pump filter.
1. Open the lower cover cap ((t)).
Turn the drain plug (<S>) to pull
out the hose.
2. Unplug the drain plug
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. Wftien water does
not flow any more, turn the
pump filter open to the left.
3. Remove any foreign objects from
the pump filter ($). After cleaning,
turn the pump filter S.) clockwise
and insert the drain plug •%) to the
original place. Close the lower
cover cap-i'.
ENGLISH