LG WM2277H Series - Installation Clearances; Level Floor Requirements; Power Outlet Requirements

INSTALLATION INSTRUCTIONS
■ Instaiiation clearances
The location must be large enough to fully open
the washer door.
■ Washer dimensions
• Most Installations require a minimum 4 in.
(10 cm) clearance behind the washer.
■ Minimum installation spacing for
recessed area installation.
The following dimensions shown are for the minimum
spacing allowed.
Additional spacing should be considered for
Installation and servicing.
• Additional clearances might be required for wait,
door and floor moldings.
• Additional spacing of 1 in. (2.5 cm) on all sides of
the washer is recommerKled to reduce noise
transfer.
Companion appliance spacing should also be
considered.
(75.6cm) (10cm)
|Side view|
(Front view)
■ Level floor
• Allowable slope under enhre washer is 1°.
• To minimize noise and vibration, the washer
MUST be installed on a solidly constructed
floor.
• Carpeting and soft tile surfaces are not
recommended.
• Never install the washer on a platform or weakly
supported structure.
NOTK: A Hnn. solid floor is es en more critical to a
frontdoadintt sva.sher than to a top>loader.
If your lloor is wood and/or frame
construction, you may need to reinforce it.
Frontdoaders use suhstanlially faster spin
speeds than tup>loaders. causing preater
vibration, if the floor is not solid, your washer
will vibrate. You will hear and feel the
vibration thn>u}:h«>ut your house.
■ Power outlet
• Must be within 60 in. (1.5 m) of ei^er side of the
washer. Do not overload the outlet with more
than one appliance.
• Time-delay fuse or circuit breaker is recommended.
NOTE: It is the personal responsibility and obligation
of the customer to have a proper outlet
installed by a qualified electrician.
6