LG WM2277H Series - Level Adjustment

INSTALLATION INSTRUCTIONS
■ Level adjustment
• Leveling the washing machine property prevents
excessive noise and vibration.
Install the appliance cm a solid arxJ level floOT surface,
preferably in a comer of the room.
• If the floor is uneven, adjust the adjustable feet as
required. (Do not irisert pieces of wood. etc. under the
feet.)
NOTI£: Kktend the feet no more Ihan necessan' tole>el
lh« wa.sher. I'bi; more the feel are extended, the
more the washer will >ibrate.
• Make sure that all four feet are stable and resting on
the floor and then check that the appliance is perfectly
level (Use a level).
• After the washer is level, tighten the lock nuts up
against of the base of the washer All lock nuts must
be tightened.
• It is critical to adjust the feet perfectly. This must be
done while the washer is spinning wi^ a load. Use the
wrench (supplied) to adjust the feet until there is no
vibration. Then tighten the lock nuts to prevent further
adjustment.
NOTK: If there are vihratkm and noise during the spin
cycle. reH'heck the le\ elinit of the washer, adjust
the feet us required, and lighten the lock nuts
securely to present changes in udjusimenl.
Run the washer with a test loud to make certain
your washer is properly leveled. Ihit
approximately 6 pounds of laundry in the
machine. Then, press I'OWKK, KIN.SK+SFIN. and
.STAKT/I*.41ISK. in that order. When the machine
spins at hi(>h speed, verify that it is stable. If not.
adjust the feel accordinyily .
* Diagonal Check
When pushing down the edges of the washing machine
tup plate diagonally, the machine should not move up
and down at all. (Please, check both directions.)
If the machine rocks when pushing the machine top plate
diagonally, adjust the feet again.
9
ENGLISH