14
INSTALLATION
• Make sure that all four feet are stable and
resting on the floor.
• Do not install the washing machine on a plinth,
stand or elevated surface unless it is
manufactured by LG Electronics for use with this
model.
2
Check if the appliance is perfectly level using a
spirit level
a
.
3
Secure the levelling feet with the lock nuts
b
by turning anti-clockwise against the bottom of
the appliance.
4
Check if all lock nuts at the bottom of the
appliance are secured properly.
• Proper placement and levelling of the appliance
will ensure long, regular, and reliable operation.
• The appliance must be 100% horizontal and
stand firmly in position on a hard flat floor.
• It must not ‘Seesaw’ across corners under the
load.
• Do not let the feet of the appliance get wet.
Failure to do so may cause vibration or noise.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between
50 kPa
and
800 kPa
(0.5‒8.0 kgf/cm²). If the water pressure
is more than
800 kPa
, a decompression device
should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
To Next Page
Loading...
