WM2688H*M Steam Washer
DISASSEMBLY/REPAIR (Control Panel)
1. Remove two screws on the back
of the top plate.
2. Pull the top plate backward and
lift, as shown.
3. Remove the detergent drawer.
4. Remove two screws behind the
detergent drawer.
5. Disconnect the connector for
the Display PWB.
6. Remove one screw from the
corner of the control panel.
7. Lift the top away from the
support rail and pull the control
panel up and away to remove.
8. Remove eight screws to
separate the control panel
and PWB.
9. Reassembly is the reverse of
these steps.
WM2688H*M Page 39 of 64 TRAINING MANUAL
To Next Page
Loading...
