WM2688H*M Steam Washer
DISASSEMBLY/REPAIR (Front Cabinet Cover)
1. Remove the top plate.
(See page 39.)
2. Remove the control panel.
(See page 39.)
3. Remove four screws that
secure the front panel.
4. Remove the screw that secures
the filter cover.
5. Use a flat screwdriver or a putty
knife to loosen the filter cover
and pull it out.
6. Stick the screwdriver into the
cover slot and pry it out
sideways to free it.
7. Drain the sump by pulling out
the little hose by the filter cover.
Let the water (maybe as much
as a quart) drain into a shallow
pan. Don’t pull the hose out so
far you kink it or the water will
not flow.
WM2688H*M Page 42 of 64 TRAINING MANUAL
To Next Page
Loading...
