WM2688H*M Steam Washer
DISASSEMBLY/REPAIR (Pump)
1. Remove the front cabinet.
(See page 39.)
2. Drain the water from the sump.
(See page 42.)
3. Remove the clamps and hoses.
4. Remove two screws and push
the pump backward and up.
5. Press down the plastic tab on
the base to slide the pump
assembly backward.
6. You can tilt the pump in either
direction to remove/replace the
individual pumps without
having to remove the tub.
Have a towel handy to catch
the spillage.
WM2688H*M Page 45 of 64 TRAINING MANUAL
To Next Page
Loading...
