LG WM2688H*M - Heater; Thermistor

WM2688H*M Steam Washer
DISASSEMBLY/REPAIR (Heater)
1. Remove the front cabinet.
(See page 39.)
2. Drain the water from the sump.
(See page 42.)
3. Remove the push-on
connectors from the heater.
4. Remove the nut that holds the
ground wire. Then loosen but
do not remove the nut that
secures the heater clamp and
pull the heater out. You may
have to wiggle it to release the
gasket.
DISASSEMBLY/REPAIR (Thermistor)
1. Remove the front cabinet.
(See page 39.)
2. Drain the water from the sump.
(See page 42.)
3. Unplug the white connector.
4. Hold the bracket and pull the
thermistor out.
WM2688H*M Page 46 of 64 TRAINING MANUAL