36
VIBRATION SENSOR CHECK
Check the
leveling of
washer,
transit bolts
and base
packing
Yes
No No
No
No
Is the connector connected
to vibration sensor
connected or assembled?
When you check the sensor
error during LQC mode.
Is it displayed “bs2”?
(Refer to 7-2)
Reconnect or
repair the
connector
Replace the
vibration
sensor
Reconnect or
repair the
connector
Replace the
TRANS
CABLE
Yes
No
Is each terminal open?
(Check the all terminal of
the vibration sensor’s
connector.
Is the connector connected
to MAIN PWB assembly
connected or assembled?
(BL2)
Is Electrical connection
correct?
(Refer to 9-10wiring diagram)
Replace the MAIN PWB
ASSEMBLY
[Note]
Chances that the cause occurs from the
main controller are very little.
Sensing part of the circuit consists of
only resistors and capacitors.
Yes
Yes
Yes
To Next Page
Loading...
