27
C
onnecting Water Supply Hose
Installation
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber packing
within the hose can adhere completely to the tap.
Water Supply Hose
Rubber Packing
Water
tap
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then tighten it
by screwing it to the right.
Check water leakage.
After connecting the hose to both the tap and the washing
machine, open the tap to check for any water leakage.
Connecting Water Supply Hose to the machine
• Connect the water supply hose to inlet valve of the washing
machine, and then lock it by turning the hose connecting
part.
• Check to see if there is a rubber seal inside the connector
before screwing to the tap.
Hose connector
Rubber seal
Screw Type
1
2
3
To Next Page
Loading...
