Note
28
Installation
Before connecting Drain Hose, check your Drain Hose model and choose the correct
instructions.
Fit the end of the drain hose to the outlet of the drain pump and tighten the clamp.
Firmly insert the free end of the drain hose into the drain opening of your home.
Make sure the soft rubber end is completely inside the drain opening.
• If the water valves and drain are built into the wall, fasten the drain hose to one of the water hoses
with the cable tie (ribbed side on inside).
• If your drain is a standpipe, fasten the drain hose to the standpipe with the cable tie provided.
C
onnecting Drain Hose
How to install the drain hose
The discharge height should be approximately 0.9~1.2m from the floor.
Do not lay down the drain hose during wash mode.
Cable Tie
0.9~1.2m
0.9~1.2m
Cable Tie
1
2
To Next Page
Loading...
