Caution
• Before cleaning the filter, the impurities in the water supply hose should be removed.
C
leaning and Maintenance
Care and Maintenance
30
Close the tap before turning off the power.
Select both Hot/Cold and then press the
[START/PAUSE] button to remove water
from the machine completely.
Turn off the power before pulling
out the cord.
• If you always use COLD water, we recommend that a WARM or HOT wash be used at a
regular intervals e.g. every 5th wash should be at least a WARM one.
Cold water washing
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The figure of power cord and water tap may vary according to the country)
•Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
When you have finished
To Clean the Filter in the Inlet Valve
After removing the water supply
hose pull out the filter.
Then use a brush to clean the
filter.
Replace the filter after cleaning it.
1 2
Push the upper part of
multi-clean filter down
and pull forward.
• Without multi clean filter, laundry may get damaged.
Open the lid and remove
lint and then wash out.
How to clean Multi clean Filter
1 2
Close the lid and at first get it back
to tub. First insert the lower part of
filter to washer tub and pull it down
until a click sounds.
3
3 4
Clean multi clean filter as often as possible. (Foreign objects accumulation may cause smell and filtering
performance will be worsened.
In order to reduce lint generation,
- laundry which creates lint easily should get turned inside out.
- Wash load sorted by color.
To Next Page
Loading...
