INSTALLATION INSTRUCTIONS 9
UNPACKING AND REMOVING SHIP-
PING MATERIAL
1. After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and is
not stuck to the bottom of the washer.
If you must layth e washer down to remove the base
packaging materials, always protect the side of the
washer and lay it carefully on its side. DO NOT lay
the washer on its front or back.
3.Carefully remove the two foam pads which
cover the top sides of the tub guide, making
sure not to leave behind any pieces of the foam.
Pad
4. Unfasten the power cord from the back of the
washer.
0
Plastic Tub Support
Carton Base
2. Save the foam block (that contains the Own-
er's Manual, parts and laundry product sam-
pies) for future use. If the washer must be
moved in the future, this will help prevent
damage to the washer during transportation.
NOTE: To prevent damage, do not remove the
foam block until the washer is at the final location.
TOOLS YOU WILL NEED
Adjustable Pliers
Carpenter's Level
To Next Page
Loading...
