4-6. TE ST R UN N IN G W ITHOUT W ATE R
To use the CHECK PROGRAM (QC TEST MODE), press BEEPER (WATER TEMP) + WASH + POWER ON
without depositing any laundry.
In QC TEST MODE all LEDs are on and press START (PAUSE) button to check over the following items.
30
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
krameR stnetnoC deyalpsiD noitcA petS
t1
All LEDs are lighted
‘Main VERSION’ and ‘Model Option
Character’
You can check ‘tE Error’
Water - -
Level frequency
Valve A
Cold valve is activated (26.7kHz is displayed as 67)
Check B
Softener Dispenser and Hot Valve
are activated
C
Jet Spray Dispenser is activated
pikS 4t
pikS 5t
t6
At water discharge level frequency
of 26.0kHz, after 50 sec., it is
automatically changed to T7.
Before the level frequency reaching
26.0kHz, level frequency is displayed after
reaching the longitude data.
-
Displays spray amount detection result
value.
(Displays Err)
Door Lock reset
Displays spray amount detection result
value.
Pulsator Mode change (Displays Err)
Pulsator stirring starts
Basket Mode change Before 500RPM: current RPM/
fter reachin
the maximum RPM, continuous
MS (40~90rpm) area for 200 sec.
Spin dry starts 500RPM or more: UB value/ UB No sense
Before 500RPM: Max emission value/
RSt: UB value
Current RPM is displayed in the units of 2
sec.
--ffo rewoP
t9
Spin Check and ‘dE’
Error check
OFF
Drain Check
t7 Load Sensing Check
After completing spray amount
detection 1 time, it is automatically
changed to t8.
-
t8 Agitate Check
‘Display Version’
-
t3
Valve operates until 23.3kHz, and the power
is automatically turned off at 23.3kHz.
(Overflow prevention)
Heater check
Alpha Check
Mode
Main version check
t2
Display Version check
And Button check
-
To Next Page
Loading...
