LG WT4801CW - Wash Cycles and Settings; Overview of Main Cycles; Cycle Setting Buttons; Setting Options Before Cycle

23
⑤ Loosen but do not remove the 6 screws that secure
the stator.
⑥ Check the direction of SNAP RING.
(The handle of snap ring is toward rotor and stator.)
⑦ Hold the stator with one hand and remove the
screws.
⑧ Be sure to keep the wiring harness out of the way
when reassembling. Damage to the wires could
cause a short or noise and interference.
7) Replacement of Bearing Housing
Assembly
① Loosen the 14 screws attaching the bearing housing
assembly and pull it up.
SNAP RING.
Hall Sensor
Stator Housing
Water Guide