25
5) Disassembly of Tub Cover and Pulsator
① Remove 8 screws and take off the tub cover.
② Remove the pulsator cap.
③ Remove the pulsator screw.
④ Remove the pulsator washer.
Tub Cover
Pulsator Cap
Pulsator
Screw
Pulsator
Pulsator Cap
Pulsator
Ball Balancer
Hub Fixing Nut
Outer Tub
Inner Tub
Stator
Rotor
Rotor Nut
Hub Attachment Nut
Shaft
Bearing Housing ASM
Inner
Tub Cap
● Hit the bar using the hammer. ● Disconnect hub nut and disassemble the inner tub.
6) Assemble the service tool (38 mm wrench)
7) Remove the hub attachment nut. (38 mm)
To Next Page
Loading...
