7. TROUBLESHOOTING SUMMARY
Pin1: Rx
Pin2: Tx
Pin3: Smps2_5v
Pin4: GND
Pin5: Standby
Pin6: Smps2_13v
Pin7: Boot
76.5 kΩ
50.6 kΩ
23.6 kΩ
16.6 kΩ
7.5 kΩ
5.6 kΩ
Error Message
IE - Inlet Error
OE - Drain Error
dE - Lid Unclosed Error
dL - Lid Lock Switch Error
LE - Locked Motor Error
FE - Over Flow Error
tE - Control Error
PE- Pressure Sensor Error
UE - Unbalance Error
Function Test while operating;
Press Custom PGM & Soil = RPM
Press Delay Wash & Soil = IPM Temp.
Press Delay Wash & Spin = Frequency
Press Extra Rinse & Spin = Water Level
Press Fabric Softener & Custom PGM = Temp.
NOTES
Test Mode
Press & Hold Test Mode Temp. & Soil
Press POWER
Press START/PAUSE to cycle thru tests
Component Mode
Voltage Tests with connectors Installed
Ohm Tests with connectors removed
To Next Page
Loading...
