To Next PageTo Next PageWhy is my LG WV7-1410W Washer not draining water?
If your LG Washer is not draining water, check if the drain hose is kinked and ensure that the drain hose is not kinked. Also, make sure that the drain hose is no higher than 1.2 m above the bottom of the appliance.
Why is my LG Washer not filling with water properly?
If your LG Washer is not filling properly, start by checking if the inlet filters on the fill valves are clogged. Also, inspect the inlet hoses for any kinks or clogs. Ensure that both hot and cold water taps are fully turned on. Finally, verify that the hot and cold supply hoses are correctly connected.
What to do if my LG WV7-1410W Washer shows a UE error?
If your LG Washer displays a UE UNBALANCE ERROR, it means the load is unbalanced. The clothes may be too wet at the end of the cycle. Rearrange the load to allow proper spinning. Close the door and press Start/Pause button. It may take a few moments before the appliance begins to spin. The door must be locked before spin can be achieved. If the load is too small, add 1 or 2 similar items or smaller articles of clothes to help balance the load. Close the door and press Start/Pause button. It may take a few moments before the appliance begins to spin. The door must be locked before spin can be achieved.
Why is my LG WV7-1410W Washer leaking water?
If your LG Washer is leaking, it could be due to several reasons. Check for clogged house drain pipes and unclog them, contacting a plumber if needed. Also, inspect the drain hose for improper installation or clogs; clean and straighten it, and regularly check the drain filter. Ensure the drain pump filter cap is correctly fitted.
Why is my LG Washer not working?
There are several reasons why your LG Washer might not be operating. First, ensure the control panel hasn't powered off due to inactivity by pressing the Power button. Check that the appliance is securely plugged into a working outlet and the water supply is fully turned on. Make sure the programme is correctly set, the door is properly closed, and the Start/Pause button is pressed. Also, inspect your house circuit breakers/fuses and reset them if necessary. If these steps don't work, try resetting the control by pressing the Power button, reselecting the programme, and pressing Start/Pause. In case of extremely low water pressure, check another tap in the house. Finally, remember that the drum may stop temporarily during heating or steaming cycles.
General| Type | Front Load |
|---|---|
| Capacity | 10.5 kg |
| Energy Rating | A+++ |
| Spin Speed | 1400 RPM |
| Color | White |
| Energy Efficiency Class | A+++ |
| Noise Level Spinning | 74 dB |
| Steam Function | Yes |
| Inverter Direct Drive | Yes |
| Smart Diagnosis | Yes |
| Inverter Motor | Yes |
| Smart Function | Yes |
| Wi-Fi Enabled | Yes |
