Connecting Peripherals
79
▶
Connecting Smart Link
It takes about 1 minute to 5 minutes depending on the notebook PC and the remote PC used before the
Smart Link
program
starts to operate after connecting the cable.
1.
Connect the
Smart Link
cable to the
Smart Link
port of the notebook PC and the USB port of the remote
PC.
※
The USB device driver is installed automatically.
※
If the operating system in the remote PC is
Windows XP
, you have to disconnect the
Smart Link
cable, remove the Smart Link
program, and reconnect the cable according to the messages displayed on the screen.
To Next Page
Loading...
