3) Press the enable switch and push the
lifting/lowering control handle in the
direction of yellow arrow. Outriggers will be
extended to level the machine. The
machine will give a warning tone when it is
level.
4) If only one outrigger is extend, the indicator
for the enabling button of lifting function will
be in red. All drive and lifting functions are
forbidden.
5) When all outriggers contact the ground
securely, the indicators of the enabling
buttons for the lifting functions and the
single outrigger button will be in green.
6) The drive function is forbidden when the
outrigger is extended.
Control of Single Outrigger
1) Press and hold one or more outrigger
buttons.
2) Press the enable switch and push the
lifting/lowering control handle for the
outrigger to level the machine according to
the desired direction.
9.12 Safety Arm Use
1) Raise the platform to a height which is
about 3.2m/10.5ft away off of the ground.
2) Lift the safety arm and move it to the middle
of scissors axle sleeve, rotate it upward
until it is vertical.
3) Lower the platform height until the safety
arm contacts the axle sleeve completely.
9.13 Auxiliary Descent
(If equipped)
When unable to lower the platform normally due
to a fault, pull the cable assembly that is located
at the rear of the machine outward.
Result: The platform will lower.
9.14 Fall Protection
1) Personal falling protection equipment
(PFPE) is not required during machine
operation. If PFPE is required in the
workplace or user rules, obey the following
regulations:
2) All PFPE must comply with corresponding
government regulations and must be
subject to check and use in accordance
with the manufacturer's instructions.
9.15 After Each Use
1) Select a safe parking position, which must
be solid horizontal ground without an
obstacle and avoid places with busy
transportation.
2) Lower the platform.
3) Turn the key switch to the "Off" position and
remove the key to avoid unauthorized use.
4) Lock the wheels.
To Next Page
Loading...
