1.10 Falling Hazards
1) All workers in the platform must use
approved safety harnesses and attach the
lanyard to the provided anchor points in the
platform. Each anchor point is limited to
one lanyard.
2) Do not climb on or sit on the guard rail of
the platform. Firmly stand on the platform
floor at all times.
3) Do not climb down the platform scissors
when the machine is elevated.
4) Keep the platform floor free from debris.
5) Shut the platform door before operation.
6) Do not operate the machine if the guard rail
is not correctly installed.
7) Do not enter or exit the platform unless the
machine is in the stowed position.
1.11 Crash Hazards
1) Pay attention to any items or obstacles
within the machine’s sight line and in any
blind spots when starting or running the
machine.
2) Pay attention to the position of the
extending platform when moving the
machine.
3) Check the workstation to avoid any
overhead barriers or other possible hazards
in the work site.
4) Pay attention to any crushing hazards
when holding the guard rail of the platform.
5) The operator must follow the
manufacturer’s service rules for personal
protection equipment, the service rules for
the workstation, and the laws and
regulations made by the local government.
6) Observe and follow the traveling arrow and
the turning direction arrows on the platform
controller and the platform’s label and
nameplate.
7) Do not operate the machine on the line of
any crane or movable overhead machine,
unless the crane controller is locked and/or
the potential bump prevention measure is
taken.
8) Dangerous driving or careless operation
when running the machine are strictly
prohibited.
9) The platform can be lowered only when
there are no personnel or barriers below
the platform.
To Next Page
Loading...
