8.1 No Operation Is Allowed
Unless
You have understood and practiced the
principles about safe operation of the vehicle in
this manual.
1) Avoid dangerous situations.
2) Always perform a pre-operation inspection.
3) Check the workplace.
4) Always perform a pre-use functional test.
5) You should understand the functional test
and inspection before proceeding with the
next step.
6) Use the vehicle only for its intended
purpose.
8.2 Basic Principles
1) Functional tests are used to detect faults
before operating the vehicle.
2) The operator must follow the steps to test
all the functions of the vehicle.
3) Do not use a malfunctioning vehicle. If a
fault is found, the vehicle must be marked
and stopped.
4) Only qualified authorized service
technicians are allowed to maintain the
vehicle according to the manufacturer's
instructions.
5) After maintenance is completed, the
operator must perform the pre-operation
inspection and functional test again before
operating the vehicle.
8.3 Functional Test
1) Choose a test place that is solid, level and
free of obstacles.
8.4 Test on the Ground
Control Station
1) Pull the red emergency shutdown button on
the platform and ground out to the "On"
position.
2) Turn the key switch to the Ground Control
Station.
Result: The LCD screen will light up and show
SYSTEM READY.
Note: LCD reading display needs to be
preheated before display under cold weather
conditions.
3) Start the engine.
Emergency Shutdown Test
1) Push the red emergency shutdown button
on the ground inwards to the "Off" position.
Result: The engine will be shut down without
running any function.
2) Pull the red emergency shutdown button
out to the "On" position and restart the
engine.
Lifting/Lowering Functions Test
The audible alarm on the machine and the
standard horn is from the same alarm. The horn
makes a continuous sound. The lowering alarm
sounds 60 times per minute. The alarm sounds
180 times per minute when the machine is tilted.
1) Do not press the lowering and lifting start
button. Press and hold the platform lifting
button.
Result: The platform shall not lift.
2) Press and hold the enabling button with
lifting functions. Press and hold the platform
lifting button.
Result: The platform shall lift.
3) Press and hold the enabling button with
lifting functions. Press and hold the platform
lowering button.
Result: The platform shall lower. When the
platform lowers, the lowering alarm shall sound.
Emergency Descent Function Test
1) Press and hold enabling button with lifting
functions while raising the platform by
about 0.6m.
2) Push the red emergency shutdown button
on the ground inwards to the off position
and turn off the engine.
3) Pull the red emergency shutdown button
out to the on position.
4) Press and hold the emergency descent
To Next Page
Loading...
