Liberty Pumps 280 User Manual (English)

Questions and Answers:

J
Jonathan WoodsAug 9, 2025
Why Liberty Pumps Water Pump won't run?
- V
  victoria59Aug 9, 2025
  If your Liberty Pumps Water Pump isn't running, there are several potential causes. It could be due to a blown fuse or power interruption, or improper voltage. Ensure the unit is securely plugged in and have an electrician inspect the wiring. The switch may be obstructed, preventing it from turning on, so ensure the pump or switch has enough clearance. Also, the liquid level might be insufficient to activate the switch. Finally, the switch itself could be defective and need replacement.
J
Jonathan GordonAug 15, 2025
What to do if Liberty Pumps Water Pump runs but doesn't pump?
- L
  Lisa CummingsAug 15, 2025
  If your Liberty Pumps Water Pump runs or hums but isn't pumping water, consider these possibilities. The discharge line might be blocked; check for any obstructions, including ice if the line runs through cold areas. The check valve could be stuck or installed backward; remove and inspect it. Ensure that any gate or ball valves are open. The pump's total lift capability might be exceeded; try routing the piping to a lower level, or consult the factory about a larger pump. Lastly, the impeller could be jammed or the volute casing plugged; remove the pump, detach the base, clean around the impeller, and reinstall.
J
Justin MillerAug 21, 2025
What to do if Liberty Pumps 280 Water Pump will not turn off?
- D
  David BurnsAug 21, 2025
  If your Liberty Pumps Water Pump won't turn off, it could be caused by a couple of things. The switch might be obstructed, preventing it from moving to the 'turn off' position. Ensure the pump or switch has adequate clearance for free operation. Alternatively, the switch itself could be defective and require replacement.
N
Nicole HardyAug 27, 2025
How to fix a noisy Liberty Pumps 280 Water Pump?
- D
  Dana HarrisAug 27, 2025
  A noisy Liberty Pumps Water Pump could be due to several reasons. There might be foreign objects in the impeller cavity; remove the pump, detach the base, clean the impeller area, and reassemble. A broken impeller could also be the culprit, consult the factory for information regarding replacement of impeller. Worn bearings can cause noise; return the pump to the factory or authorized repair station for repair. Finally, rigid piping attachments to the building can transmit noise; replace part of the discharge line with a rubber hose or connector.
R
Richard IrwinSep 2, 2025
Why does Liberty Pumps Water Pump run periodically?
- J
  Jacqueline KennedySep 2, 2025
  If your Liberty Pumps Water Pump runs periodically even when fixtures aren't in use, it could be due to a check valve issue. The check valve might be missing, stuck open, or leaking; remove and inspect it for proper function and installation. Another possibility is leaking fixtures; repair any leaks to stop the pump from cycling unnecessarily.

Liberty Pumps 280 Specifications

General

Model	280
Horsepower	1/3 HP
Voltage	115V
Discharge Size	1-1/2" NPT
Cord Length	10 ft
Switch Type	Vertical Float
Phase	Single Phase
Type	Automatic Submersible Sump Pump
Motor Housing Material	Cast Iron
Material	Cast Iron