To Next PageTo Next Page
Need help?Do you have a question about the Liberty Pumps SJ10 and is the answer not in the manual?
General| Type | Submersible sump pump |
|---|---|
| Voltage | 115V |
| Construction Material | Cast iron |
| Operation | Automatic |
| Cord Length | 10 ft |
| Seal Type | Mechanical seal |
| Float Switch Included | Yes |
| Discharge Size | 1-1/2 inch |
| Switch Type | Vertical float switch |
| Phase | Single phase |
Highlights risks of contamination, electric shock, and water hammer during operation and installation.
Details required water pressure, discharge air gap, and acceptable water types for operation.
Provides instructions on using pipe dope, purging lines, and fitting installation for the SumpJet inlet.
Introduces the SumpJet as an emergency backup system and outlines warranty claim procedures.
Explains the SumpJet's design for municipal water backup and its water consumption ratio.
Covers inspection upon receipt, proper storage, and essential maintenance for idle pumps.
Details the availability and installation of an optional audible high water alarm (ALM-P1).
Details required backflow prevention devices and discharge air gap specifications.
Emphasizes disconnecting power and prohibits garden hoses, requiring permanent piping.
Guides connecting the municipal water supply using SharkBite fittings and proper pipe preparation.
Instructs on mounting the SumpJet, setting float level, and routing the discharge pipe.
Warns against overtightening fittings, using PTFE tape, and heat transfer from copper pipes.
Covers turning on water supply, checking for leaks, testing operation, and reconnecting the primary pump.
Provides guidance on modifying sump covers and alternative mounting methods if needed.
Details the 3-year warranty, what it covers, and conditions that void the warranty.
Lists conditions like improper installation, misuse, or modifications that are not covered.
