To Next PageTo Next Page
Need help?Do you have a question about the Liberty Pumps LE40 Series and is the answer not in the manual?
General| Discharge Size | 1-1/2" NPT |
|---|---|
| Solids Handling | 1/2" |
| Motor Housing | Cast Iron |
| Thermal Protection | Yes |
| Warranty | 3 Years |
| Voltage | 115V |
| Cord Length | 10 ft |
| Switch Type | Vertical Float |
| Impeller Material | Thermoplastic |
| Seal Type | Mechanical |
| Weight | 22 lbs |
Lists the available pump models and their horsepower.
Details critical warnings about electric shock and general hazards.
Explains safety alert symbols and their meanings.
Warns about fire hazards associated with product usage and installation.
Highlights severe risks from improper installation or operation.
Provides guidance on selecting pumps based on specifications and performance.
Outlines procedures for inspecting pumps upon receipt and proper storage methods.
Explains automatic and manual float switch operations and settings.
Details pre-installation steps, including basin requirements and preparation.
Covers wiring and connection requirements for pump installation.
Explains how to check and correct pump rotation for 3-phase models.
Describes requirements for check valves, gate valves, and discharge piping.
Details how to use the piggyback switch for temporary manual operation.
Illustrates direct wiring for automatic 1-phase pumps.
Explains typical installation setups for single and dual pump systems.
Steps for verifying components and initial system start-up.
Covers routine checks and common issues with pumps.
Provides a table of common problems, causes, and corrective actions.
Details the terms and conditions of the product warranty.
