To Next PageTo Next Page
Need help?Do you have a question about the Liberty Pumps LSG200 Series and is the answer not in the manual?
General| Discharge Size | 2" NPT |
|---|---|
| Construction Material | Cast Iron |
| Impeller Material | Cast Iron |
| Horsepower | 2 HP |
| Motor Type | Oil-filled |
| Cord Length | 20 ft |
| Solids Handling | 2" solids |
| Seal Material | Carbon/Ceramic/Buna |
Precautions to prevent serious injury or death from electrical hazards.
Precautions to prevent fire hazards associated with the pump system.
Warnings for hazards that could result in injury, death, or property damage.
Important information for pump installation and operation.
Verify pump sizing for intended installation to ensure proper performance.
Details on pump design, models, and specification references.
Check pump and spare parts for damage after shipment.
Guidelines for storing pumps to prevent damage and maintain seals.
Details on control panels, overload protection, and motor thermostat for pump operation.
Connect pump and control wiring per manufacturer's diagrams.
Verify correct 3-phase pump rotation before installation.
Basin must be sealed and vented; clean debris and inspect equipment.
Manually rotate cutter to check for free movement and lubricate seals.
Connect wiring, verify rotation, and ensure proper electrical setup.
Install guide rails and position pump correctly in basin.
Make discharge connections, install check valve, and vent basin per codes.
Verify plumbing components are installed correctly and functional.
Check pump for corrosion and wear quarterly; motor is oil-filled.
No repair work during warranty without prior factory approval.
Limited warranty for 3 years from date of purchase, covering defects in material and workmanship.
