Network Settings
32
5.5 Telnet Server
Use the Telnet Server Menu to enable or disable access to the Web
card through a Telnet interface.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change this setting:
1. Choose IP Network Settings from the Main Menu, then Telnet Server.
2. Choose Telnet Server, then specify:
• Enabled to permit Telnet access
• Disabled to block access via Telnet
Web Interface
To access Telnet settings through the Web interface:
• Click on the Configure tab, then Telnet in the left panel and finally Edit in the right panel.
After making changes, click Save.
Telnet Server Menu
-------------------
1: Telnet Server 'enabled'
<ESC>: Cancel menu level
Please select a key ?>
To Next Page
Loading...
