Liebert IntelliSlot Installation Manual

Connect to the Card - Terminal Emulation, Telnet or Web Interface
A3
A.2.3 Open the Telnet Interface
To connect to the card using Telnet:
1. Open a Telnet connection on a computer with an Ethernet connection to the Liebert unit.
To do this:
• Open a command prompt window—click the Start button, then
Run.
• Enter cmd and click OK.
• In the command prompt window that opens, enter telnet fol-
lowed by a space and the IP address of the Web card—for exam-
ple:
telnet 192.168.0.125
2. When the message at right appears in the command prompt window,
press the Enter key.
3. Enter the Administrator username and password (both are case-
sensitive):
a. Login (username—default is Liebert)
b. Password (default is Liebert)
A.2.4 Open the Web Interface
To connect to the card using the Web interface:
1. Open a Web browser such as Internet Explorer.
2. Enter the IP address of the Web card in the address bar—e.g., 192.168.0.125.
3. Click on a tab at the top of the window.
C:>telnet 192.168.0.125
RTCS v2.96.00 Telnet server
Service Port Manager Active
<Esc> Ends Session
Login: Liebert
Password: ********
Configure and
Support Tabs

Liebert IntelliSlot Specifications

General

Form Factor	Plug-in module
Connectivity Technology	Wired
Model	Liebert IntelliSlot
Device Type	Network Card
Compatibility	Liebert UPS systems
Network Protocols	TCP/IP, SNMP, HTTP, HTTPS
Data Link Protocol	Ethernet
Remote Management Protocol	SNMP
Management	Web-based, SNMP
Security	Password protection, HTTPS
Power Supply	Powered by UPS
Features	Event logging
Compliant Standards	FCC, CE