Liebert Static Transfer Switch - Figure 33 Installation Drawing, Seismic Floor Stand 100-250 A

Installation Drawings
46
Figure 33 Installation drawing, seismic floor stand 100-250A
FRONT
FRONT
REAR
REARFRONT
LEVELER FOOT
DETAIL C
(3 PLACES) CAP SCREW M12-1.75 x40mm SPLIT LOCK WASHER M12 FLAT WASHER M12
REAR LOWER STS2 BRACKETREAR
FIG. 3
TOP VIEW OF FLOOR STAND
WITH LOWER REAR MOUNTING BRACKET
FRONT UPPER STS2 BRACKET
FRONT
(2 PLACES) CAP SCREW M12-1.75X40MM SPLIT LOCK WASHER M12
FLAT WASHER M12 (SEE DETAIL C) (2 PLACES) CAP SCREW M12-1.75X40MM SPLIT LOCK WASHER M12 FLAT WASHER M12
REAR UPPER STS2 BRACKETREAR SIDE
REAR LOWER BRACKET
FIG. 4
RIGHT SIDE VIEW OF FLOOR STAND
WITH LOWER REAR MOUNTING BRACKET
INSTALLATION DRAWING
FOR SEISMIC FLOOR STAND
100-250A STS2
NOTE:
SEE DWGS PS215000, PS215002, AND PS215003
FOR DETAILS.
FIG. 1
BOTTOM VIEW OF STS2 WITH UPPER BRACKETS
FIG. 2
RIGHT SIDE VIEW OF STS2 WITH UPPER BRACKETS
LEVELER FOOT NUT
REAR UPPER STS2 BRACKET
FRONT UPPER STS2 BRACKET
PS215001 Rev. 0