Liebert Static Transfer Switch - Figure 37 Installation Drawing, Seismic Floor Stand 400-600 A

Installation Drawings
50
Figure 37 Installation drawing, seismic floor stand 400-600A
FRONT
FRONT
REAR
REARFRONT
LEVELER FOOT
DETAIL C
(3 PLACES) CAP SCREW M12-1.75 x40mm SPLIT LOCK WASHER M12
FLAT WASHER M12
REAR LOWER STS2 BRACKETREAR
FIG. 3
TOP VIEW OF FLOOR STAND
WITH LOWER REAR MOUNTING BRACKET
FRONT UPPER STS2 BRACKET
FRONT
(2 PLACES) CAP SCREW M12-1.75X40MM SPLIT LOCK WASHER M12
FLAT WASHER M12 (SEE DETAIL C) (2 PLACES)
CAP SCREW M12-1.75X40MM SPLIT
LOCK WASHER M12 FLAT WASHER M12
REAR UPPER STS2 BRACKETREAR SIDE
REAR LOWER BRACKET
FIG. 4
RIGHT SIDE VIEW OF FLOOR STAND
WITH LOWER REAR MOUNTING BRACKET
NOTE:
SEE DWGS PS216000, PS216002, AND PS216003
FOR DETAILS.
FIG. 1
BOTTOM VIEW OF STS2 WITH UPPER BRACKETS
FIG. 2
RIGHT SIDE VIEW OF STS2 WITH UPPER BRACKETS
LEVELER FOOT NUT
REAR UPPER STS2 BRACKET
FRONT UPPER STS2 BRACKET
PS216001 Rev. 0