13
B.CONTINUOUS DRAINAGE
2.Please make sure to clean the condensed water in the tank and put the tank in the
original position.
3.If the water tank is dirty, please rinse it with clean water. Avoid using detergents,
steel wire balls, chemical dust removers, diesel, benzene, diluents or other solvents.
Otherwise, it can damage the tank and cause leaks.
4.Put the water tank in its original position. Otherwise, the indicator light will always be red
and the machine cannot start working again.
1.Take out the PVC pipe, Straighten the drain pipe.
2.Insert one end of the drain pipe into the drain outlet at the top of the tank and connect the
other end to the bathroom, floor drain, outdoor or bucket like container or defined drain area.
1.Please do not block the drainage outlet or drainage pipe, if blocked, condensed water may
overflow and result to water leakage.
2.Please do not bend the drain pipe. The height of the drainage pipe should be lower than
the drainage outlet.
3.The drainage pipe must be firmly connected to the drainage outlet.
Do not submerge the end of drainage pipe into water; otherwise it may cause "Air Lock" in
the pipe ,the water may not flow smoothly and result to water leakage.
WARNING
Drainage pipe
To Next Page
Loading...