12
DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
1.Pull out the water tank 2.Empty the water tank 3.Replace the empty tank back
into the unit
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once
you empty the water tank and installed properly.
1. When the tank is full, The machine will buzz for 5 times, and the “Water Tank Full” indicator light
will light up.
2.Press the POWER button to turn off the unit.
3.Pull on the water tank and simply slide out of the body of the dehumidifier.
4. Empty the water into an area with a drain or outside.
5. Clean the inside of the tank as well as the outside.
6.Replace the empty tank back into the unit.
7.Press the POWER button to resume operating.
8.If the Water Full light does not extinguish, check that the float is correctly in place.
WARNING
1.Do not discard the magnets and plastic rivets in the tank. Otherwise, the dehumidifier cannot
be started, or the machine will not automatically stop working when the water tank is full,
and the condensed water overflow will damage the floor of the room.
A.EMPTYING THE WATER TANK
To Next Page
Loading...