Lifepro DynaFlex - Operating Instructions; Battery Charging and Indicators; Using Your DynaFlex: Speed and Application; Attachment and Arm Adjustments

12 DynaFlex User Manual Lifepro SoarFX Collection 13
OPERATING INSTRUCTIONS
Please read the operating instructions before using the DynaFlex.
Keep this manual for reference.
CHARGING THE BATTERY
• Always power off the DynaFlex
before charging.
• To charge: plug the charging
adapter into the port on the
base of the battery/handle.
Plug the other end of the
adapter into a wall outlet.
• Fully charge your DynaFlex
before using it for the first
time.
• Your DynaFlex should take
3–5 hours to charge.
• You may charge the battery separately, or while it is attached to the
body of the massage gun.
• The 3 Battery Charging Lights on the handle flash during charging. When
the battery is fully charged, the 3 lights will be green and remain lit.
• During use, 4 Battery Indicator Lights on the LCD screen indicate the
following battery levels:
• 4 Lights lit = 60–100% • 2 Lights lit = 10–30%
• 3 Lights lit = 30–60% • 1 Light lit = <10%
• Average run-time is 4–5 hours per charge at high speed and up to
25 hours at low speed.
USING YOUR DYNAFLEX
1. Press the LCD screen for one second to wake the LCD screen.
2. Then, press and hold the Power/Speed button for 3 seconds to power
on the DynaFlex. Vibration will begin automatically at speed level 1.
The first Speed Indicator Light will light up to indicate speed level 1 is
selected.
0° 30° 60° 90°
3. Tap the Power/Speed button to toggle through the 16 vibration speed
levels. Tap once to set the vibration speed to level 2. Tap a second
time for speed level 3. Tap a third time for level 4, and so on. Press and
hold the Power/Speed button to move quickly through the 16 vibration
speed levels. The 16 Speed Indicator Lights will indicate the selected
speed level.
4. At the desired vibration speed, float the head of the massage
attachment along a muscle group. Apply pressure as needed.
5. Press and hold the Power/Speed button for 3 seconds to power off the
unit.
6. Always power off the unit after each use.
REMOVING AND REPLACING A MASSAGE ATTACHMENT
1. Press and hold the Power/Speed button for 3 seconds to power off the
unit.
2. Grab the inserted attachment and firmly pull out to remove it.
3. Insert the stem of a new attachment into the nozzle of the unit.
4. Press the attachment in firmly to secure it.
REMOVING THE BATTERY
1. Press and hold the Battery Release button on the side of the DynaFlex.
2. Firmly pull down on the battery/handle with your other hand to remove it.
ROTATING THE MASSAGE ARM
1. Press and hold the Arm Rotation button while pushing the massage
arm up.
2. The massage arm can rotate
to four angles: