SECURE THE ASSEMBLED SEAT
TO THE BIKE FRAME
1. Locate the seat adjustment knob (15) on the back of the seat post
insert (14).
2. Loosen the knob (but do not remove it) by turning it counter-clockwise.
3. Pull the knob head out and slide the seat post (13) into the seat post
insert (14). A "click" indicates that the seat post is locked into position.
4. Tighten the knob to secure the seat post by turning it clockwise.
NOTE: Adjust the seat to your desired height after the bike is fully
assembled. See
ADJUST THE SEAT HEIGHT on page 22 for instructions.
7
Endurance Training Collection 17 16 VeloCycle User Manual Lifepro Endurance Training Collection 17
INSTALL TWO AA BATTERIES
IN THE CONSOLE
1. Locate the two AA batteries (32) in the tool/accessory bag.
2. Remove the battery compartment cover on the back of the
console (29).
3. Insert two AA batteries into the battery compartment according to the
polarity markings in the compartment.
4. Replace the battery compartment cover.
CAUTION: Never mix old batteries and new batteries. Only use AA
batteries with the console.
8
Cover
32
29
(32) x2
TOOLS & HARDWARE
15
14
13
To Next Page
Loading...
