Lifepro THRIVE - Page 6

OPERATING INSTRUCTIONS
Please read the charging and operating instructions before using the
Thrive. Keep this manual for reference.
USING THE REMOTE TO OPERATE THE THRIVE
1. LCD Screen: Screen shows current mode, intensity level, heat level, and
battery level.
2. Power Button: Press and hold the button to power the Thrive on and off.
3. Mode Button: Toggle through the six modes, M1-M6.
4. Intensity Button: Toggle through the three intensity levels: low, medium,
and high.
5. Heat Button: Toggle through the three heat levels: low, medium, high.
USING YOUR THRIVE
1. Press and hold the Power button to power on the Thrive. Compression will
automatically begin in Mode 1, at low intensity and low heat. To adjust the
intensity, mode, and heat:
2. Press the Mode button to toggle through the six modes:
a. Mode 1: Cycles through calf massage, foot massage, then simultaneous calf
and foot massage. The intensity level gradually increases.
b. Mode 2: Massages the calf only.
c. Mode 3: Massages the entire foot, from toe to ankle.
d. Mode 4: Massages calf to toe to calf in a circular motion. The intensity level
gradually increases.
e. Mode 5: Cycles through calf massage, then foot massage.
f. Mode 6: Provides a relaxing foot massage.
3. Press the Intensity button to toggle through the three air compression intensity
levels: low, medium, and high.
4. Press the Heat button to toggle through the three heat levels: low (95°), medium
(113°), and high (131°).
5. Press and hold the Power button to power off the unit. Always power off the unit
after each use.
The ThrivePlus will automatically power off after 20 minutes of use. For best results,
do not use continuously for more than 1 hour.
CHARGING THE BATTERY
• Fully charge your Thrive for up to 3 hours before using it for the first time.
• The Battery Indicator on the remote screen indicates the current battery level.
• Average run-time is 1.5-2 hours per charge.
SoarFX Collection 11
5
4
3
2
1
TIPS FOR USING YOUR THRIVE
• Sit, or lie, comfortably. Do not stand
while using the unit. Do not cross your
legs.
• We recommend beginning with the
lowest intensity and increasing intensity
once your feet and legs get used to the
intensity.
• The unit will automatically power off
after 20 minutes of use. For best
results, do not use continuously for
more than one hour.
• Check the areas you are treating
frequently and stop immediately at the
first sign of pain or discomfort.
• Use only on dry, clean clothing or skin. If
you wish to wear pants and/or socks, we
recommend thin, form-fitting leggings
and thin socks). Do not wear pants with
zippers or buttons on the legs.