Lifetime 60030 - Step 1.5: Secure Table Top Channel; Step 1.6: Attach Sliding End Caps

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
8
SEC
1
2 ADULTS REQUIRED FOR THIS STEP
SEC
1.5
Set the Table Top Channel back in place. While another adult holds the Legs, reinsert the five (5) screws you
removed in step 1.1 into the holes of the Table Top Channel to secure it in place. Do not overtighten.
Reinsert all five Screws
removed in step 1.1
BWI
BWI
SEC
1.3
Lay the Table Legs and Table Leg Braces down flat on the Table Top. Place a Sliding End Cap (BWI) on the ends of
the tube on a Table Leg as shown.
SEC
1.6
BWH
BWH
BWH (x5)
All removed in Step 1.1
BWI (x2)