Lifetime 6426 - Page 13

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
13
SEC
SEC
2.3
Tip the Wall Panel inward.
NO HARDWARE REQUIRED FOR THIS PAGE
SEC
2.4
Use a long flat screwdriver to gently pry the bottom corner of the Wall Panel so that it has room to slide on the
inside of other Wall Panels. Slide the Wall Panel to the left, and then remove the Panel. Repeat Steps 2.2 - 2.4 for
the other side of the shed.
2
Note: You’re Shed may be a different length than the Shed shown, but the
ideas are the same.
Note: To remove a Wall Panel, slide it to the left (when looking at it from inside the shed) until it lifts out.
!
!