Lifetime 90135 - Step 4.3: Slide Steering Tube Through Nose; Step 4.4: Install Steering Wheel

35
TOOLS AND HARDWARE REQUIRED
X SECTION 4 (CONTINUED)
4.3
4.4
ATK (x1)
ARX (x1)
CVZ (x1)
CQK
CQI
CQJ
ARX
CVZ
ATK
CVZ
!
• You may need to use a screwdriver to press the Washers into the recess in the
plastic. Securely tighten all hardware after all of the parts in this step have
been attached.
• Slide the Steering Tube (CQI) through the front of the Nose all the way to the Dashboard side of the assembly.
• Place the Formed Washer (ATK) at the end of the Steering Tube, and align the notch on the nub in the steering
wheel as shown in Sec 4.2. Place the Steering Wheel (CQJ) over the Steering Tube. Secure with the hardware
shown.
3/16 in/po (≈5 mm)
(2)