Lifetime 91025 - Getting Ready to Cook; First-Use Heat Cleaning

9
9
GETTING READY TO COOK
4. Push and hold down the igniter button (you should hear clicking) while pushing in and turning
the right-most temperature control knob to HIGH. The burner should ignite.
NOTE: if ignition does not take place within 5 seconds, immediately turn the control knob to the OFF
position. Wait 5 minutes to give any released gas time to dissipate, then repeat the last step for this
burner.
5. Repeat the last step for the remaining three burners.
NOTE: if the rst burner lit, the remaining three should light automatically when the temperature-
control knobs are turned to HIGH.
NOTE: if the burner still does not light, verify there is gas in the propane tank. If you do not hear
clicking sounds when depressing the igniter, check to see if there is a battery. Replace if necessary.
6. Run the grill on HIGH for 15 minutes to ensure all factory residue has been burned o the grates,
burners, burner shields and cook box.
NOTE: subsequent heat cleanings kill bacteria and burn o food residue accumulated from the last
grilling.
1. Ensure all temperature knobs are in the OFF position (staight up).
2. Open the lid.
NOTE: ALWAYS keep the lid open while starting the grill or smoker.
3. Fully open the handwheel to the propane tank by turning the handwheel counter-clockwise until
it stops.
BEFORE USING YOUR NEW LIFETIME® FUSION FUEL™ GRILL & PELLET SMOKER FOR THE FIRST TIME
You should perform a rst-use heat cleaning before using your smoker/grill for the rst time. A rst-use heat cleaning sterilizes the interior surfaces of the cook box by burning o any
residue left behind from the manufacturing of the grill. The heat-cleaning process takes approximately 15 minutes. Ensure all packing materials have been removed from the smoker/pellet
grill before doing the following:
NOTE: this should be done whether you’re planning to grill or smoke your food.
Handwheel
Igniter button
Right-most temperature
control knob